starter

I have a 62 with327/340HP. When I start it, it will run as long as I hold the key in the start position (not good) as soon as I let go, it quits. I hear a whining sound, it is probably the starter still engaged with the flywheel. How do I diagnose this problem? Is it the starter, the switch, or something else?

[c4c5specialist]

HI there,
Sounds like your switch is shorted out, not supplying power to the ignition, EXCEPT when your key in the start position.
Simply check for B+ power at the terminal at the coil when you ignition is ON, not start.
That will tell you if your getting power there.
Allthebest, c4c5

[Itshakes]

Replace your Ballast Resistor. It's on the firewall, in the engine compartment, it looks like a white block with one screw on each end and a wire attached to each screw. There is a strap that holds it in position. I think Corvette Central has them. Part # 591030---$21.95 ea.

[ken mohr]

Check for power at resistor too, before purchase. You will need to keep going back until you have power. When you have power the last item was bad. I too think you will get back to the switch.

Good luck. Hope it goes well
Ken

Thanks Guys, I'll try the cures suggested tonight. Morrie

[Itshakes]

You can take one wire off the resistor and fasten it under the other screw/wire. Then see if it will start. If it starts and runs with the key in the run position, then replace the resistor.

[jhbalaji]

Change your switch it have been repaired try to change it works well when you change the switch... Thanks c4c5 specialist...