10-21-2010, 05:05 pm
| #1 | ||||||||||||||||||||
| Corvette Enthusiast Join Date: Aug 2008 Location: Milford, CT Posts: 33
Thanks: 0
Thanked 0 Times in 0 Posts
|  driveshaft install
I have a 94 six speed. Where does the balance weight on the driveshaft go,towards the differential or the transmission?
| ||||||||||||||||||||
|  | ||||||||||||||||||||
|
11-19-2010, 05:53 am
| #2 | ||||||||||||||||||||
| GM World Class Certified Technician  Join Date: Nov 2006 Location: New Haven Ct Posts: 5,141
Thanks: 10
Thanked 511 Times in 498 Posts
 |
HI there, Depends, I have seen them on both ends, but normally mark the shaft prior to removal. If the shaft has been balanced after removal from the car, I prefer to install the weight to the differential side. That is only my preference and there is NO service information to factually base my response, its just what I do. Allthebest, c4c5 | ||||||||||||||||||||
| Updates on events: www.facebook.com/corvettemechanic Additional information http://thecorvettemechanic.com | |||||||||||||||||||||
|
| | ||||||||||||||||||||
 |
« Previous Thread
|
Next Thread »
| Thread Tools | |
| Display Modes | |
Linear Mode
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| header install | chdmac99c5 | C5 Technical Questions | 1 | 03-03-2010 03:59 am |
| PAL install in 2005 without XM | bterwilliger | C6 Technical Questions | 1 | 09-16-2009 08:03 am |
| LS3 install | RLSEBRING | C6 Technical Questions | 12 | 03-31-2009 07:49 pm |
| TPMS install | Mr Cool | C6 Technical Questions | 2 | 03-16-2009 08:11 am |
| Balancing a driveshaft | TBone | C4 Technical Issues | 17 | 09-05-2008 06:28 am |